Assembly video of solar charging pile

How does an electric vehicle charging pile work?

An electric vehicle charging pile provides two charging modes: regular charging and quick charging. Users can swipe a specific charging card on the human-computer interaction interface provided by the charging pile to carry out corresponding operations such as selecting the charging mode, charging time, and cost data printing, etc.

How do I set up the Charging Pile?

To set up the Charging Pile, follow these instructions: Enter the system menu page by clicking ‘system’ at the bottom left of the homepage. A username and password dialog will appear. Use the following credentials: Username: USER, Password: 4567. Click ‘OK’ to enter the system setting page.

What are the characteristics of an electric vehicle charging pile?

As the electric vehicle charging pile (bolt) on the power distribution side of the power grid, its structure determines that the characteristics of the automatic communication system are many and scattered measured points, wide coverage, and short communication distance.

What is the protection level of the charging pile (bolt)?

m) The protection level of the charging pile (bolt) complies with the IP54 requirements of “GB 4208-1993 Enclosure Protection Level (IP Code)”; The input end of the charging pile is directly connected to the AC grid, and the output end is equipped with a charging plug for charging the electric vehicle.

How to choose a charging pile (bolt)?

The charging pile (bolt) should have a good shielding function against electromagnetic interference; ⑤ The bottom of the pile (bolt) body should be fixedly installed on a base not less than 200mm above the ground. The base area should not be larger than 500mm×500mm; 3. Power requirements 4. Electrical requirements

What should be included in an AC charging pile (bolt)?

① The AC charging pile (bolt) should be equipped with an emergency stop switch, which can stop charging in an emergency by manual or remote communication; ② The AC charging pile (bolt) should have the leakage protection function on the output side;