Common failures of capacitors include

What are the common failure modes of capacitors?

Common and less well known failure modes associated with capacitor manufacture defects, device and product assembly problems, inappropriate specification for the application, and product misuse are discussed for ceramic, aluminium electrolytic, tantalum and thin film capacitors.

What causes a capacitor to fail?

In addition to these failures, capacitors may fail due to capacitance drift, instability with temperature, high dissipation factor or low insulation resistance. Failures can be the result of electrical, mechanical, or environmental overstress, "wear-out" due to dielectric degradation during operation, or manufacturing defects.

What is the failure mode of electrolytic capacitors?

The failure mode of electrolytic capacitors is relatively slow and manifests over periods of months rather than seconds which can be the case with short circuit capacitor failure modes. Therefore condition monitoring may be practical and useful for these components.

Why do paper and plastic film capacitors fail?

Paper and plastic film capacitors are subject to two classic failure modes: opens or shorts. Included in these categories are intermittent opens, shorts or high resistance shorts. In addition to these failures, capacitors may fail due to capacitance drift, instability with temperature, high dissipation factor or low insulation resistance.

What happens if a power supply capacitor fails?

Power supply capacitors are often subjected to voltage surges and rapid switching, which can induce premature failure. The implications of capacitor failures in PCBs are far-reaching, ranging from minor signal degradation to complete system breakdown.

What happens if a capacitor fails in open circuit mode?

The open circuit failure mode results in an almost complete loss of capacitance. The high ESR failure can result in self heating of the capacitor which leads to an increase of internal pressure in the case and loss of electrolyte as the case seal fails and areas local to the capacitor are contaminated with acidic liquid.